Tempe Roofing Pros provides professional fascia & soffit in Tempe, AZ for residential and commercial properties across the East Valley. Rot is rarely what takes out a fascia board in Tempe. Sun does. Paint chalks and fails on the south and west elevations, the wood behind it checks and splits, and the fasteners work loose while the board is still perfectly dry.
That changes what a repair should be. Replacing a split board and painting it the same colour buys you a few years of the same failure, so we prime all six sides of new material before it goes up, back-prime the cut ends, and specify a finish rated for this exposure rather than whatever happened to match. Primed end grain is most of the job. Sun-driven failure needs a coating strategy, not a carpentry one.
The edge metal above the fascia matters more than the board does. On a low-slope roof the gravel stop or drip edge is what keeps water off the wood at all, and once the coating along that termination has cracked, every rain runs behind the metal and into the top edge of the fascia. We fix the termination and the board together. Wood dries out, and a bad termination keeps refilling it.
Stucco soffits and eaves are the other half of the work here. Cracks at the parapet, at the soffit-to-wall junction, and around vent screens open up with thermal movement, and they get patched with the wrong material constantly. Elastomeric patching over a properly cleaned and keyed crack holds, while a smear of caulk over a dirty crack does not. Keying a crack out before patching is the whole difference.
Soffit vents deserve a look while the ladder is up, because they are frequently the reason an attic runs hot. Painted-over screens, insulation packed against the inside face, and stucco skinned across a vent opening all show up on Tempe houses, and each of them starves the intake side of whatever ventilation the roof has. Intake is the half of ventilation nobody checks.
Subterranean termites are a fact of life in this valley and they do reach wood at the roof line where a patio cover or a trellis touches the ground. If we find galleries in a fascia or a rafter tail we will tell you, and we will point you to a licensed pest control operator rather than pretending it is a roofing repair. Pointing you at a different trade costs us nothing and saves a repeat repair.
Our licensed and insured team brings the right materials and equipment to every job — sprayed polyurethane foam at three-pound density, acrylic elastomeric coating meeting ASTM D6083, high-solids silicone topcoat, dry film thickness measured in mils, electronic capacitance moisture survey, dusk infrared thermography scan — and backs the work with a written workmanship warranty. We serve Tempe and nearby communities including Mesa, Chandler, Gilbert, Scottsdale.
What We Handle
Everything our fascia & soffit in Tempe covers
One crew, one point of contact, and the full range of fascia & soffit work in Tempe, AZ. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia and soffit repair
- fascia board replacement
- soffit repair
- stucco soffit crack repair
- what is a soffit
- fascia rot repair
- drip edge replacement
- soffit vent repair
- rafter tail repair
- eave repair
- fascia repair Tempe
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Tempe services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with sprayed polyurethane foam at three-pound density, acrylic elastomeric coating meeting ASTM D6083, high-solids silicone topcoat, dry film thickness measured in mils, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Tempe job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the East Valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Tempe
Tempe Roofing Pros covers Tempe and the surrounding communities of the East Valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Mesa, AZ — Maricopa County, population 504,258
- Fascia & Soffit in Chandler, AZ — Maricopa County, population 275,987
- Fascia & Soffit in Gilbert, AZ — Maricopa County, population 267,918
- Fascia & Soffit in Scottsdale, AZ — Maricopa County, population 241,361
- Fascia & Soffit in Phoenix, AZ — Maricopa County, population 1,608,139
- Fascia & Soffit in Queen Creek, AZ — Maricopa County, population 59,519
Start on the Tempe Roofing Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Tempe Chooses Tempe Roofing Pros
- ✓Every coating proposal names the product, its ASTM standard and the dry film thickness in mils, never a gallon count
- ✓Core cuts and an electronic moisture scan before a recoat is priced, because coating over wet foam buys nothing
- ✓Thickness readings taken at the same marked points every visit, so you see a wear rate instead of one afternoon's opinion
- ✓Ponding corrected by building slope in foam rather than patched with more material at the low spots
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Tempe follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Tempe gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Tempe, or request a quote and we'll get right back to you.